D-Link DES-3010F Command Line Interface Manual page 182

config 802.1x auth_parameter ports
Restrictions
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DES-3026:4#config 802.1x auth_parameter ports 1 – 20
direction both
Command: config 802.1x auth_parameter ports 1 – 20
direction both
Success.
DES-3026:4#
config 802.1x auth_protocol
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DES-3026:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DES-3026:4#
config 802.1x init
Purpose
Syntax
Description
Parameters
DES-3000 Series Layer 2 Switch CLI Reference Manual
Only Administrator-level users can issue this command.
Used to configure the 802.1x authentication protocol on the
Switch.
config 802.1x auth_protocol [local | radius_eap]
The config 802.1x auth_protocol command enables you to
configure the authentication protocol.
[local | radius_eap] – Specify the type of authentication protocol
desired.
Only Administrator-level users can issue this command.
Used to initialize the 802.1x function on a range of ports.
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports
[<portlist> | all] {mac_address <macaddr>}]
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
port_based ports – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can then be
specified.
 <portlist>  Specifies a port or range of ports to be initialized.
178