Port Security Commands - D-Link DES-3010F Command Line Interface Manual

The port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config port_security ports
show port_security
delete port_security_entry vlan_name
clear port_security_entry port
enable port_security trap_log
disable port_security trap_log
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
[<portlist> | all ] {admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-10> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset]}
{ports <portlist>}
<vlan_name 32> mac_address <macaddr> port <port>
<portlist>
NOTE: The uplink module ports (DES-3010F/FL/G ports 9-10, DES-3018 ports
17-18, DES-3026 ports 25-26) do not support the port security function.
Used to configure port security settings.
config port_security ports [<portlist> | all] {admin_state [enable |
disable] | max_learning_addr <max_lock_no 0-10> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset]}
This command allows for the configuration of the port security feature. Only
the ports listed in the <portlist> are affected.
ports <portlist>  Specifies a port or range of ports to be configured for port
security.
all  Configure port security for all ports on the Switch.
admin_state [enable | disable] – Enable or disable port security for the listed
ports.
max_learning_addr <max_lock_no 0-10> - Use this to limit the number of
MAC addresses dynamically listed in the FDB for the ports.
lock_address_mode [Permanent | DeleteOnTimeout | DeleteOnReset] –
Indicates the method of locking addresses. The user has three choices:

Permanent – The locked addresses will not age out after the aging
timer expires.

DeleteOnTimeout – The locked addresses will age out after the
aging timer expires.

DeleteOnReset – The locked addresses will not age out until the
Switch has been reset.
Only Administrator-level users can issue this command.
P S
ORT ECURITY
167
27
C
OMMANDS