D-Link DES-3010F Command Line Interface Manual page 150

config mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch's MAC address table notification global settings:
DES-3026:4#config mac_notification interval 1
historysize 500
Command: config mac_notification interval 1
historysize 500
Success.
DES-3026:4#
config mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable port 7 for MAC address table notification:
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#disable mac_notification
Command: disable mac_notification
Success.
DES-3026:4#
Used to configure MAC address notification.
config mac_notification {interval <int 1-2147483647> | historysize <int 1-
500>}
MAC address notification is used to monitor MAC addresses learned and
entered into the FDB.
interval <sec 1-2147483647> – The time in seconds between notifications. The
user may choose an interval between 1 and 2,147,483,647 seconds.
historysize <1-500> – The maximum number of entries listed in the history log
used for notification.
Only Administrator-level users can issue this command.
Used to configure MAC address notification status settings.
config mac_notification ports [<portlist | all] [enable | disable]
MAC address notification is used to monitor MAC addresses learned and entered into
the FDB.
<portlist> – Specify a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC address table
notification on the Switch.
Only Administrator-level users can issue this command.
146