The Programming Setup For Telemetry Sensors - GRAUPNER m-12 HOTT Operating Instruction

- RECEIVER
You may program the telemetry voice function of receiver, TEMP, STRENGTH, RX
VOLT, LOWVOLT, Press DOWN buttons to go to RECEIVER line and press ENT button
to access to RECEIVER setup mode. All voice function of TEMP, STRENGTH, RX VOLT,
LOWVOLT have been set to use. Press the direction button to select the desired line
and press ENT button to unmark the box if you don't want to use voice function for the
desired line.
press
press
- If the optional sensors are attached, the telemetry voice functions of an attached option-
al sensors can be programmed. It is need to add the function for the optional sensor at
SENSOR SELECT mode then VOICE TRIGGER article is created. Below is the example that
VOICE TRIGGER article is created.
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC

20. The Programming Setup For Telemetry Sensors

press
Press the direction button on transmitter home screen to go to receiver telemetry screen.
ENT
Connect the optional sensors to receiver then press UP/DOWN button to check and pro-
TEL VIW
gram the desired optional sensors.
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
73