Rx Curve - GRAUPNER m-12 HOTT Operating Instruction

press

16-5. RX CURVE

Perform the exponential programming setup at RX CURVE mode. You may program
the exponential value of channel 2,3,4. The default setup is B curve that leads Servo
responds proportionally depending on transmitter throttle movement. A curve leads that
Servo responds sensitively and C curve leads that Servo responds softly.
Press ENT button to access to highlight the default channel 20 on CURVE 1 CH line
then press UP/DOWN buttons to select the desired channel. The default setup is CH2
AILE, CH3 ELEV, CH4 RUDD. Press ENT button to remove the highlight and press UP/
DOWN button to access TYPE line. Press ENT button to highlight the default value B
then press UP/DOWN buttons to select one of A, B, C. CURVE2 and 2 can be set in the
same method with CURVE1.
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
press
press
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
65