GRAUPNER m-12 HOTT Operating Instruction page 58

- CENTER
The value of servo center in the selected channel at OUTPUT CH can be programmed. The
center value depends on transmitter throttle and trim position. General servo center value is
1500us. Press DOWN button to access to CENTER line then press ENT button to highlight
the default value 1500usec. Move and hold transmitter throttle at the desired position then
press ENT button, the center value corresponding to throttle position is set.
press
- TRIM
the servo trim can be set. Press DOWN button to access to TRIM entry then press ENT
button to highlight the default value -000usec. Press UP/DOWN button to program the desired
value and then press ENT button to remove the highlight.
press
58
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
- LIMIT + / -
ENT
The maximum value for each direction can be programmed so that the maximum servo
TEL VIW
travel limit of the connected servo is adjusted. The default value is 150% but the servo
ESC
travel range is limited to 100% that is programmed at SERVO EPA of transmitter so the
servo limit is not operated at 150% ~ 100%, but operated at below 100%. If SERVO EPA of
transmitter is set to 150%, the LIMIT value can be set below 150%. Press DOWN button to
access to LIMIT+/- line then press ENT button to highlight the default value 150%.
Press UP/DOWN button to program the desired value and then press ENT button to remove
the highlight.
ENT
TEL VIW
ESC
press
press
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC