Rx Fail Safe - GRAUPNER m-12 HOTT Operating Instruction

press
- PERIOD
The servo response time for transmitter throttle can be adjusted. All channels that servo
connected are applied separately. Press DOWN button to access to PERIOD line then
press ENT button to highlight the default value 20msec. Press UP/DOWN button to set
10msec or 20msec and then press ENT button to remove the highlight.
press
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC

16-3. RX FAIL SAFE

OUTPUT CH (receiver)/ INPUT CH (transmitter): It is used to perform the programming
setup of transmitter channel that is bound to receiver. The default setup is that each channel
1,2,3,4,5,6 of receiver is connected to the same channel 1,2,3,4,5,6 of transmitter. In case that
R16, 16 channel receiver, is bound to mz-12, 6 channel transmitter, this function is very useful.
For example, 4 aile, 4 flap are used in aircraft, 1~4 channels can be set to aile and 5~8 chan-
nels can be set to flap and then other channels can be set to elev or rudd. Press the direction
button at EX SERVO mode to go to RX FAIL SAFE mode. OUTPUT CH line has been selected
at RX FAIL SAFE mode. Press ENT button to highlight the default value 1. Press UP/DOWN
ENT
button to select the desired channel and then press ENT button to remove the highlight. Press
TEL VIW
DOWN button to access to INPUT CH line. Press ENT button to highlight the default value 1.
ESC
Press UP/DOWN button to select the desired channel that is connected INPUT CH and then
press ENT button to remove the highlight.
press
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
59