Rf Sett (Aircraft And Helicopter) 29P; Stick Mode 30P; Receiv Out 31P - GRAUPNER m-12 HOTT Operating Instruction

6. RF sett (Aircraft and Helicopter)
The RF function of the transmitter can be programmed, it contains 6 models of stick mode,
timer, receiv out, rx bind, range test, RF transmit.
• Stick mode
The mz-12 has four stick modes with the two dual axis sticks. The user can select one among
the four default stick modes the default mode is the mode 1.
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
• Timer
The mz-12 has four stick modes with the two dual axis sticks. The user can select one among
ENT
the four default stick modes the default mode is the mode 1.
TEL VIW
ESC
• Receiv out
For the maximum flexibility of the receiver socket assignment, the mz-12 provides to swap over
the servo outputs 1 to max.6. If you try to use more than 1 servos at the aileron or the elevator or
the rudder, the receiver output socket can be assigned as you intend.
• Rx bind : The receiver must be bound to the transmitter before the receiver will operate. Binding
ENT
teaches the receiver the specific code of the transmitter, so it will only connect to that transmitter.
TEL VIW
ESC
• Range test : The Range Test function reduces the power output. This allows for a range test to
confirm the RF link is operating correctly. Perform a range check at the beginning of each flying
press
session to confirm system operation.
• RF transmit : RF transmit function allows to turn on/off the RF power output
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
29