Rx Bind 31P; Range Test 31~32P - GRAUPNER m-12 HOTT Operating Instruction

- Receiv out
Press the direction button to select the receiv out line then press the ENT button to access the
function. The cursor is on the arrow mark then press the ENT button to access the function.
-The default channel assignment-
The default channel assignment appears on the screen.
Press the direction button to select S1~S6 then press the
Channel Output
ENT and the direction buttons to highlight and change to
Throttle S1 Output 1
the desired channel. Press the ESC button to get back to
Output 2
Aileron S2
the previous screen.
S3 Output 3
Elevator
NOTE: If you change S1 to S2, the S2 have the 2 chan-
Rudder Output 4
S4
nels of output 1 and output 2 so the both servo of output
Output 5
5 Channel S5 1 and output 2 are simultaneously moved when the stick
6 Channel Output 6 of the S2 is move.
S6
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
- Rx bind
Press the direction button to select rx bind line then the cursor is at the hyphen. Turn on the
receiver then press the ENT button on the receiver for over 3 seconds so that the receiver
enter the binding mode. Press the ENT button of the transmitter, the system will be connect-
ed within a few seconds and the model name of the receiver is displayed on the screen after
completing the bind.
press
ENT
TEL VIW
ESC
- Range test
Press the direction button to select the range test, the cursor is at the 99sec. Turn on the re-
press
ceiver then press the ENT button on the transmitter. With the range test started, the Graupner
ENT
logo blinks with beep for 99sec. Walk over 50 meters away from the model with controlling the
TEL VIW
transmitter sticks constantly and check whether the model is operating normally. You should
ESC
have total control of the model with the trainer switch pulled.
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
31