GRAUPNER m-12 HOTT Operating Instruction page 68

press
press
press
68
press
ENT
TEL VIW
ESC
ENT
CH OUT TYPE
TEL VIW
ESC
You may decide the signal output type of receiver. 5 types of ONCE / SAME / SUMO12/
SUMI / SUMD HD12 are available.
press - ONCE
It is use for analogue servo. If ONCE is selected, PERIOD on RX SERVO is set to
ENT
20msec automatically.
TEL VIW
- SAME
ESC
It is use for digital servo. If SAME is selected on CH OUT TYPE line, you need to set
PERIOD on RX SERVO to 10 ~ 20msec. when analogue servo is used, 20mse should
be set.
- SUMI
ENT
Receiver get the signal of the receiver performed the SUMO programming setup then
TEL VIW
outputs the signal
ESC
- SUMD HD
The digital output signal of all channels in receiver is outputted from the selected channel.
press
It is used to the product that needs the receiver digital signal such as Power box and Flybar-
ENT
less system. The factory default for SUMD HD output channel is the last channel of receiver
TEL VIW
and you may change it.
ESC
- SUMO
Only the selected channel outputs the signal of all channels of receiver. In case that 1
receiver is set to SUMO and the other receiver is set to SUMI and then they are connect-
ed in ex code, the receiver set to SUMI outputs the signal came from the receiver set to
ENT
SUMO. The final channel of receiver is set to SUMO output channel, but you may change
TEL VIW
to the desired channel.
ESC
Press DOWN buttons to access CH OUTPUT TYPE and press ENT button then the
default value SAME is highlighted. Press UP/DOWN buttons to set the desired value and
press
press ENT button to remove the highlight. When you select SUMO 12 and SUMD HD12
ENT and try to select the different output channel, press ENT button to move the highlight to 12
TEL VIW then press UP/DOWN button to select the desired channel. Press ENT button to remove
ESC
the highlight.
ENT
TEL VIW
ESC