Mode 2; Change Control Mode; Fail-Safe Function - GRAUPNER HoTT mz-8P Manual

ENGINE OFF CAMERA ACRO

Change control mode

Fail-Safe function

S1032_mz-8P_V1.1sh
Forward and backward (nick)
The transmitter mz-8P HoTT is delivered as standard only in Mode 2,
with throttle / pitch and yaw on the left. This configuration can be
changed via firmware update to Mode 4, with throttle / pitch and
yaw on the left.
The required software "S1032_MZ-8P_M34_xxx.bin" can be down-
loaded free of charge from the mz-8P HoTT product page at
www.graupner.de.
MODE 2 (Throttle/Pitch left)
Motor / Pitch
Motor / Pitch
Note
After switching to mode 4, the control function "yaw" is on the right
and the roll function on the left control stick.
If the radio connection is interrupted for less than approx. 0.5 sec-
onds, the factory setting is to "hold" the control signals last recog-
nized as correct. If the disturb lasts longer, the motors will be
switched "OFF" after expiry of this period.
MODE 4 (Throttle/Pitch left)
Nick Motor / Pitch
Nick
Motor / Pitch
Nick
Nick
17 / 24