Fail Safe; Servo (S View) - GRAUPNER X-8E Manual

FAIL SAFE

NORMAL
BACK
MODE POS
FREE
ST
FREE
TH
FREE
CH3
FREE
CH4
DELAY
100ms
STO
SET
NORMAL
BACK
MODE POS
HOLD
ST
F/S
0%
TH
FREE
CH3
FREE
CH4
DELAY 100ms
STO
SET

SERVO (S View)

NORMAL
BACK
0%
ST
+100%
L150%
TH
F150%
+100%
0%
CH3
CH3
36 / 48
Fail Safe settings menu. In case of receiver signal loss or inter-
SERVO
ruption, assign the servo channel to a predefined position. For
example, set an engine-powered model to idle (or an elec-
tric-powered model to shut off), so the model does not move
uncontrollablly.
FREE: Channel is empty with no failsafe assigned.
HOLD: Holds the servo in the previous position.
F/S: The servo automatically moves to a defined position
To set the position: Press and change the channel line button
to F/S. A percent value button will appear to the right in the POS
column. Press the percent button to select and set servo posi-
SERVO
tion by moving the related control. Press the SET button to con-
firm. The POS button displays the assigned position of the
servo. Press the STO button to save all settings before exiting.
DELAY: To set the delay time between signal loss and failsafe
launch, press the button on the DELAY line to choose between:
50ms, 100ms, 250ms, 500ms, 750ms and 1.0s. Press the
STO button to save all settings before exiting.
Attention
To store settings, press the STO button on the bottom of the
screen before exiting this menu. Settings will not be saved until
the STO button is pressed and the "Position stored" confirma-
tion message appears.
Servo monitor (display only).
This display shows the servo travels of all four control channels.
Access this display by pressing the Servo icon in the main menu,
or by pressing the Servo button in the upper right corner of most
R150%
submenu displays.
B150%
0%
0%
S1008_X-8E_jh_V1