Power Safety Precautions; Power Source; Disconnecting Power - Xerox Phaser 6100 Service Manual

1.3 Power Safety Precautions

1.3.1 Power Source

For 110 VAC printers, do not apply more than 140 volts RMS between the supply conductors or between either
supply conductor and ground. Use only the specified power cord and connector. For 220 VAC printers, do not apply
more than 260 volts RMS between the supply conductors or between either supply conductor and ground. Use only
the specified power cord. This manual assumes that the reader is a qualified service technician.
Plug the power cord, with a grounding prong, into a grounded AC outlet only. If necessary, contact a licensed
electrician to install a properly grounded outlet. If the product loses its ground connection, contact with conductive
parts may cause an electrical shock.

1.3.2 Disconnecting Power

Turning the power off using the On/Off switch does not completely de-engergize the printer. You must also
disconnect the printer power cord from the AC outlet. Position the power cord so that it is easily accessible during
servicing so that you may power down the printer during an emergency. Disconnect the power plug by pulling the
plug, not the cord.
Disconnect the power cord in the following cases:
if the power cord or plug is frayed or otherwise damaged,
if any liquid or foreign material is spilled into the case,
if the printer is exposed to any excess moisture,
if the printer is dropped or damaged,
if you suspect that the product needs servicing or repair,
whenever you clean the product.
Precautions
Service Manual 1-3