Curved Or Distorted Vertical Lines; Low Toner; Replace Toner [Color] - Xerox Phaser 6100 Service Manual

Troubleshooting

8.4.10 Curved or Distorted Vertical Lines

Symptoms: Curved, wavy or distorted vertical lines on prints.
Checks and Causes
Use EDC mode to test the laser.
Check the +24V signal between the main board
(CN12) and the laser.

8.4.11 Low Toner

Symptoms: "Replace [Color] Toner Soon" is displayed on the control panel.
Checks and Causes
If 10% or less toner remains in any of the
cartridges, this message will be displayed.
Check the condition of the contacts on the
DEVE_OEM Board.

8.4.12 Replace Toner [Color]

Symptoms: "Replace [Color] Toner Soon" is displayed on the control panel.
Checks and Causes
"Replace [Color] Toner Soon" is displayed when
the cartridge life is over 100%. Image Density may
be reduced. Engine would not print if cartridge life
is over 110%.
8-16
Repair Actions
Replace the laser
Replace the main board.
Repair Actions
Check the toners percent remaining using the control panel.
If the toner is low or empty, replace toner cartridge.
Replace the DEVE-OEM board.
Replace the main board.
Repair Actions
Replace the toner cartridge.