Xerox Phaser 6100 Service Manual page 139

Voids or White Areas
Example
The paper is wet or moist.
Some parts of the image are blank
and/or wrinkled in appearance.
The defect appears only while duplex
printing.
Lateral Lines - Possible Repeating Defect
Example
Check the distance of the repeating
defect to the corresponding unit.
Is the defect is within 1 ~ 2 mm?
Is the defect in an irregular pattern?
Evenly Repeating Defect
Example
Check the distance of the repeating
defect to the corresponding unit.
Is the defect is within 1 ~ 2 mm?
Is the defect in an irregular pattern?
Possible Cause
Possible Cause
Possible Cause
Sequence of Repair Actions
Use a fresh ream of dry paper and inspect the
storage area for the media.
Replace the fuser.
Replace in the following order; imaging unit, toner
cartridge, transfer belt where contamination has
been found.
Replace the duplex unit.
Sequence of Repair Actions
Refer to the table in section 7.5 of this manual and
replace the corresponding unit if necessary.
Replace the laser.
Replace the imaging unit.
Sequence of Repair Actions
Refer to the table in section 7.5 of this manual and
replace the corresponding unit if necessary.
Replace the laser.
Replace the imaging unit.
Service Manual 8-9
Troubleshooting