Xerox Phaser 6100 Service Manual page 153

Page to complex
The layout of the document is too complex
Replace Transfer Roller Soon
The transfer roller is nearing it's end of life.
Ready IP Conflict
IP address confilict with the address of another
device on the network.
Install Imaging Unit
This occurs when the imaging unit is not correctly
installed or seated properly.
Install Transfer Belt
There is a problem with the transfer belt.
Occurs when the transfer belt is not correctly
installed or locked.
Occurs when the value of the resistor cnnot be
detected due to contamination of the contacts.
1. Try printing again after after simplifying and/or erasing
any unnecessary images. If the message recurs
repeatedly, you will need to add more memory.
Note Note Note
Xerox does not currently support adding memory
1. Replace the transfer roller when the image quality
becomes unacceptable.
2. You can select whether this message displays on the
control panel or not.
3. Remember to reset the transfer roller life at the control
panel after replacing with a new roller.
1. This only occurs when the optional network interface card
is connected and an IP address conflict is detected.
Change the IP address.
1. Verify the imaging unit is properly installed.
2. Replace the imaging unit.
3. Check the imaging unit harness to the main board.
Reseat or replace if defective.
4. Replace the main board.
1. Verify the transfer belt is properly installed and locked.
2. Clean the contacts on the transfer belt.
3. Replace the transfer belt.
Troubleshooting
Service Manual 8-23