Xerox Phaser 6100 Service Manual page 154

Troubleshooting
Install [Color] Toner
Occurs when the toner cartridge of the indicated
color is not installed.
If the toner cartridge is not installed.
The resistor cannot be read due to the
contamination of the contact points.
Tray 2 Error
Tray 2 is not installed properly.
Cover D Open
Tray 2 cover is open.
Waste Cartridge Full/Not Installed
Waste toner cartridge is full or not installed.
8-24
1. Verify the toner cartridge is installed.
2. Check the contact point for contamination.
3. Replace the toner cartridge.
4. Replace the DEVE_OEM board, the HVPS or the main
board.
1. Turn off the printer and re-insert Tray 2.
1. Open and close the Tray 2 cover properly.
2. If the fault continues, refer to section 8.3.6 for additional
troubleshooting.
1. Check the waste toner cartridge for proper installation.
2. If it is full, replace the waste toner cartridge.
3. Check the waste toner sensor and actuator for damage or
defects. Replace if defective.
4. Check the waste toner sensor, cable harness. Re-seat or
replace if defective.
5. Replace the main board.