Error Messages - Symbol Series 6800 Product Reference Manual

Series 68XX Product Reference Guide

Error Messages

If ERR3000 is loaded in the system configuration, the terminal displays the following
messages to indicate error conditions that affect system performance. A message is usually
accompanied by one or more beeps, after which the system returns to its previous status.
The application can change the actual wording of the messages or disable messages. The
messages listed in Table 7-1
Programmer's Guide or your application guide for additional information.
Message
Double Key Error
Low Battery
Dead Battery
Power Fault
7-2
are representative. Refer to the Series 3000 Application
Table 7-1. Error Messages
Two or more keys were pressed at the same time.
The battery pack should be recharged or replaced as soon as
possible.
Replace or recharge the battery pack immediately. This message
is programmable, so it may be worded differently. See your
application guide. After this message is displayed, the terminal
shuts itself off.
The last terminal power off was caused by a terminal power
failure. Possible causes of a power fault include:
• the battery pack is removed with the terminal on.
• the terminal is dropped.
• the batteries lose power suddenly.
• the terminal displays a low battery power error message, and
you attempt to power the terminal on without recharging or
replacing the batteries.
Explanation