Symbol Series 6800 Product Reference Manual page 41

Series 6800 Product Reference Guide
Note: Versions of SENDHEX earlier than 3.0 do not support flow control.
If you use an earlier version and encounter communication errors, use
a lower baud rate.
4. SENDHEX displays the prompt:
Press <Enter> to begin communications.
5. Do NOT press <ENTER> yet. Before starting communications (refer to
Communications), set up the terminal as directed in Initiate Terminal
Communications.
Initiate Terminal Communications
1. Boot the terminal to command mode. Refer to
68XX, for a list of the boot to command mode sequences.
The terminal displays the following:
2. Scroll through Command Mode options using UpArrow or DownArrow until
"Program loader" is displayed. Press <ENTER>.
3. The terminal displays:
Before loading the new application, erase the NVM's original contents.
Note: To cancel this operation, press <CLEAR>.
4. Press <ENTER> to erase the EEPROM.
Wait while the EEPROM is erased. When complete, the program prompts for the
communications parameters.
3-4
COMMAND MODE
Select function
Self test
Program loader
WARNING: EEPROM
WILL BE ERASED
CONTINUE? <ENT>
Chapter 5, Operating the Series
Starting