Connecting Power to the 38/6860 CCM
Only the power connection is required for charging batteries in the CCM.
1. Install the power supply.
a. Attach the power supply to the left side of the CCM as shown in Figure 2-13
using two cross-head screws.
b. Connect the power supply plug to an AC wall outlet.
2. When the CCM is connected to power, all the LEDs flash at the same time for 3
seconds, flash once from left to right, and turn on for 3 seconds before going out.
Power Supply
Insert Screw
Insert Screw
Null Modem Cable
Figure 2-13. Connecting the 38/6860 CCM for
Charging and Communications
LEDs
Hardware Setup
CCM
2-13