Symbol Series 6800 Product Reference Manual page 52

g. Select Terminal Sleep Mode from the main configuration menu. The Terminal
Sleep Mode screen
Figure 4-8. Terminal Sleep Mode Screen
To change the current Terminal Sleep Mode, use the
between the "On" and "Off" settings. The default setting is "On".
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
h. Select Boot Mode from the main configuration menu. The Boot Mode screen
(Figure 4-9) is displayed.
To change the current boot mode, use the
settings: "Manual entry", "BOOTP", and "DHCP". Refer to Appendix E for a
complete explanation of the three boot modes.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
(Figure 4-8) is displayed.
TERMINAL SLEEP MODE
Radio state:
On
áâ, Clear, Enter
BOOT MODE
IP address from:
Manual entry
áâ, Clear, Enter
Figure 4-9. Boot Mode Screen
Spectrum24 RF Terminal Setup
áâ
cursor keys to toggle
áâ
keys to toggle among the three
4-9