Battery Chargers; Ubc Chargers; Printer Interface Module (Pim); Pc Adapter - Symbol Series 6800 Product Reference Manual

Series 68XX Product Reference Guide
Accessories
The following accessories are available for 68XX terminals.

Battery Chargers

68XX terminals use a five-cell 780 mAh or six-cell 600 mAh (intrinsically safe) Nickel
Cadmium (NiCd) battery. NiCd batteries are charged using one of the charging accessories
listed below.
Cradles
Cradles combine a communications device and battery charger, and are available with either
one or four slots.
38/6860 Charging and Communications Module (CCM) — Four-slot module for
t
charging NiCd battery packs in the terminal and spare battery packs; also performs
communications between terminals and a host, modem, or printer. Refer to Chapter
2, Hardware Setup.
38/6865 Cradle Base Unit — Single-slot cradle for charging NiCd battery packs; also
t
performs communications between terminals and a host, a modem, or a printer.
Refer to Chapter 2, Hardware Setup.
38/6866 Cradle Base Module — Four-slot cradle for charging NiCd battery packs in
t
the terminal and for communicating between terminals and a host, a modem, or a
printer. Refer to Chapter 2, Hardware Setup.

UBC Chargers

The NiCd battery pack can be recharged in a UBC 1000 or 2000 battery charger.

Printer Interface Module (PIM)

The Printer Interface Module works with the PC Adapter to perform communications
between the terminal and a host PC or a printer without a cradle. Refer to the section
PC Adapter on page

PC Adapter

The PC Adapter works with the PIM to communicate with the host PC without a cradle or
to charge a NiCd battery pack in the terminal without a cradle. Refer to the section
Adapter on page 2-16.
1-4
2-16.
The
The PC