Initializing The Series - Symbol Series 6800 Product Reference Manual

Initializing the Series

To initialize a 6840 which has LWP.HEX version 3.03 or greater loaded:
Note: This section covers specific settings required on first booting the 6840
out of the box. For a complete review of the CFG24 screens, refer to
Appendix E, Spectrum24 Utilities.
1. Insert a charged battery in the 6840. Refer to Chapter 6 for instructions on charging
and installing a battery.
2. Cold boot the 6840.
For the 46-key 6840:
s Press and hold <A + B + D>.
s Press and release PWR.
s Release <A + B + D>.
3. The 6840 loads software, then brings up the Spectrum24 Configurator (CFG24)
menu, shown in
Note: CFG24 comes up automatically after the first initialization out of the
box. On subsequent initializations, type CFG24 at the DOS prompt
to bring up the configurator.
Figure 4-1.
Spectrum24 RF Terminal Setup
4-3