Starting Communications - Symbol Series 6800 Product Reference Manual

Series 6800 Product Reference Guide

Starting Communications

1. The terminal is ready to receive the program from the host PC and displays:
2. Press <ENTER> on the terminal.
3. Press <ENTER> on the host computer. SENDHEX begins transmitting the program
image. When communications are established, the terminal displays:
During program loading, the display shows the program segment address being
transferred (XXXX).
4. When the transmission is complete, the terminal displays:
A status of 0000 (all zeros) indicates a successful transfer. Other status values
indicate an error. These values are provided in
Codes.
If you received an error, press <Clear> on the terminal to return to the Command
Mode main menu.
Ending Communications
To return to the Command Mode main menu:
1. Press <Clear> on the terminal.
2. Power down the terminal.
3. Detach any cables connected to the terminal.
4. Reboot the terminal using the appropriate cold boot sequence described in
5, Operating the Series
3-6
Comm Parameters
Start? <ENT>
Program loader
Receiving: XXXX
Program loader
Status 0000
68XX, in the section Booting a Series 68XX.
Appendix B, Communications Status
Chapter