Running _L.bat - Symbol Series 6800 Product Reference Manual

where:
SENDHEX
<file name>
38400
[1|2]
The following message is displayed:
Press <ENTER> when remote is ready. ESC to abort...
3. Do NOT press <ENTER> yet. Set up the 6840 using the _L.BAT utility as directed
in the section

Running _L.BAT

1. Place the 6840 in a configuration cradle.
2. Power the terminal on.
3. At a DOS prompt on the 6840, type _L<ENTER> using the keystrokes listed below.
For the 46-key 6840:
<SHF><FUNC><G><L><ENTER>
4. The terminal boots and displays the message:
5. Press <ENTER> on the host PC.
6. The batch file runs Program Loader with the communications parameters set to
38,400 bps, 7 data bits, odd parity, and no flow control. The 6840 displays the
screen:
is the command
is the hex file for the application being loaded. There may be other
application hex files which load other software (e.g., STEP version 2.6.0 or
greater, or TelNet Clients 3.0 or greater) to the flash disk.
Note: Be sure to use applications that are flash-disk enabled.
is the baud rate.
sets the host communications port the cradle is attached to.
Running _L.BAT.
Symbol Technologies
NVM Loader 2.X-XX
Connecting to Host
Symbol Technologies
NVM Loader 2.09-XX
Spectrum24 RF Terminal Setup
4-13