Coupling Ccms - Symbol Series 6800 Product Reference Manual

Series 68XX Product Reference Guide

Coupling CCMs

Up to four 38/6860 CCMs can be coupled together for table or wall mounting, with power
provided by a single power supply attached to the left-most CCM. To couple two or more
CCMs for table or wall mounting:
1. Verify that add-on 3861-101 kit contains the following parts:
s 1 CCM
s 1 coupling bracket
s 6 cross-head screws
s 2 flat-head screws
2. On the add-on (or right-hand) CCM, use 3/16-inch driver to remove the jack screws
securing the communications port, ONE AT A TIME, and replace them with the flat-
head screws.
Note:Be sure to remove the jack screws one at a time; otherwise, the
connector will fall into the housing.
3. Mate the power port on the right side of the first cradle with the power port on the
left hand side of the second cradle.
4. Place the coupler between the CCMs, aligning the holes in the coupler to the holes
in the CCM's base (Figure 2-12).
5. Install 6 cross-head screws through the coupler into the CCMs and tighten.
6. If you wish to wall mount the coupled CCMs, proceed as directed in Wall Mounting
the CCM.
2-12
Screws
Coupling
Screws
Figure 2-12. Coupling Two CCMs