Arming In The Latchkey Mode; Initiating Panic Alarm - Visonic PowerMaster-10 G2 User Manual

OPERATING THE POWERMASTER SYSTEM
Forced arming "HOME" is performed in a similar manner, as follows:
PRESS
[Enter code] /
[Present tag]
(to mute the buzzer)
Go to interior zone
ARM indicator flashes during the armed state.

Arming in the Latchkey Mode

This mode, if enabled by the installer, is useful for a parent at work who wants to be sure that his children have
returned from school and have disarmed the system. A special "latchkey" message will be sent out when the
system is disarmed by a "latchkey user".
Latchkey users are holders of user codes or users of keyfob transmitters 5 through 8 (PowerMaster-10 G2) / 23-
32 (PowerMaster-30 G2). The latchkey message is considered an alert and not an alarm, and is therefore sent
to the private telephones programmed by the user as targets for alert messages.
Latchkey arming is possible only when you arm "AWAY". To arm in the Latchkey mode, proceed as follows:
PRESS
(Within 2 seconds)
Vacate the premises
Note: Latchkey must be enabled by your installer.
ARM indicator lights during the armed state.
Initiating Alarms
Following are various methods that may be used for initiating alarms.

Initiating Panic Alarm

You can generate a panic alarm manually in the disarmed and armed states. The sequence will be as shown:
PRESS
simultaneously
To stop the alarm, press the
12
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE _ _ _ _
Code / Present tag
ARMING HOME
PLEASE EXIT NOW
↓
(Exit delay)
HOME HH:MM
RESULTING DISPLAY
ARMING AWAY
ARMING LATCHKEY
(alternating)
PLEASE EXIT NOW
↓
(Exit delay)
AWAY
RESULTING DISPLAY
PANIC ALARM
READY HH:MM
button and then key in your valid user code.
↓
↓
D-304829 PowerMaster-10/30 G2 User's Guide