Volume Control - Visonic PowerMaster-10 G2 User Manual

B.15 Volume Control
The system allows you to adjust the volume level of the various system beeps, chime signal and voice prompts,
and to enable or disable status dependent, pre-recorded verbal messages (Voice option) that are heard over
the built-in loudspeaker.
Here you can enable / disable the Voice option and change the volume level of the following:
♦ Keypad beeps
♦ Chime signal
♦ Exit/Entry beeps
♦ Confirmation beeps
♦ Trouble beeps
♦ Voice commands
Carefully read the section titled "Additional Information" according to the indicated references
table at end of this section.
A. To Adjust the Volume Level of the Keypad Beeps
1.

VOLUME CONTROL

2.
KP beeps vol.
MID
3.
or
MAX
4.
MAX
☺
Return to step 2
B. To Adjust the Volume Level of the Chime Signal
5.
or
6.
Chime signal vol
MID
or
7.
MAX
8.
MAX
☺
Return to step 6
D-304829 PowerMaster-10/30 G2 User's Guide
Enter the [USER SETTINGS] menu, select the [
option and press
KP beeps vol.
The display will read [
The display shows the currently selected option.
Click the or
volume level for the keypad beeps, for example, [MAX].
When you are satisfied with the setting, press
☺ sounds. The display confirms the saved setting, then
A "Happy Tune"
4, 7, 8
returns to step 2.
Click the or
vol], and press
The display shows the currently selected option.
Click the or
volume level for the chime signal, for example, [MAX].
When you are satisfied with the setting, press
☺ sounds. The display confirms the saved setting, then
A "Happy Tune"
4, 8
returns to step 6.
MENUS AND FUNCTIONS
1
.
]. To enter this option press
button until the display reads the desired
button until the display reads [Chime signal
.
button until the display reads the desired
1
etc – see
VOLUME CONTROL
]
2
3
6
to confirm.
2
3
6
to confirm.
.
45