Arming Away Or Home 'Instant; Forced Arming Away Or Home - Visonic PowerMaster-10 G2 User Manual

Arming AWAY or HOME 'Instant'

Pressing during the exit delay will arm the system in the "Instant' mode, i.e. without an entry delay.
Therefore, any detection in any zone will trigger an immediate alarm. To arm AWAY-INSTANT, proceed as follows.
PRESS
Vacate the premises
ARM indicator lights during the armed state.

Forced Arming AWAY or HOME

Forced arming allows you to arm the system even if the system is "NOT READY". Any open zones will be
bypassed for the duration of arming.
Note: When forced arming is carried out, the buzzer "protests" by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the system when NOT READY is displayed, proceed as shown:
PRESS
[Enter code] /
[Present tag]
(to mute the buzzer)
Vacate the premises
ARM indicator lights during the armed state.
D-304829 PowerMaster-10/30 G2 User's Guide
OPERATING THE POWERMASTER SYSTEM
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE _ _ _ _
Code
ARMING AWAY
ARMING INSTANT
(alternating)
PLEASE EXIT NOW
↓ (Exit delay) ↓
AWAY
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE _ _ _ _
Code / Present tag
ARMING AWAY
PLEASE EXIT NOW
↓
(Exit delay)
AWAY
Remember: Forced arming compromises security!!
↓
11