Periodic Test Per Partition - Visonic PowerMaster-10 G2 User Manual

TESTING THE SYSTEM

Periodic Test per Partition

In addition to the regular Periodic Test, you can also test zones for enrolled sensors (excluding temperature
sensors and sirens) that are assigned to a selected partition.
A. To Conduct the Periodic Test per Partition
1. P1:R P2:N P3:-
MEMORY
TROUBLE
2. SELECT PARTITION
3. Partition 1
4.
PERIODIC TEST
5.
ENTER CODE:
6. CODE
P1 SENSORS TEST
7.
8. NOT ACTIVE NNN
↓ ↓ ↓ ↓
DEVICE TESTS END
9.
☺ Return to step 3
1
Partitioning must be enabled by your installer.
2
If you have not already changed your personal code number, use the default setting – 1111.
3
To abort, press the
4
To activate system devices during the "Periodic Test Per Partition"; make sure the device LED lights when
activated:
Contact sensor:
Motion sensors:
Smoke sensors:
5
Periodic test per partition will be interrupted (the panel returns to selected partition display) upon occurrence of
one of the following: 1) Disarm event by keyfob, keypad or pendant assigned to a selected partition;
FIRE or EMERGENCY
56
1
Make sure the selected partition is disarmed and the other partitions are not
in exit or entry delay and then press the partition (
When the display reads [SELECT PARTITION], press the partition number of
the zones you wish to test, for example,
Press the
and press
The screen will now prompt you to enter your Master user code.
Enter your Master user code.
3
To enter the devices test procedure per partition, press
The display reads [NOT ACTIVE NNN]. NNN indicates the number of enrolled
devices in the panel that have not been tested yet. This number automatically
drops one count for every tested device.
Test per partition is performed by activating each device as explained in point
4 in the Additional Information table below.
After a device has been activated, the control panel reads [Zxx IS ACTIVATED]
and the "N" indicator drops one count.
After all devices have been tested, the control panel reads [DEVICE TESTS END].
Press
Additional Information (Periodic Test per Partition)
button; the display reads [<OK> TO END]. Press the
Open or close the door or window protected by the contact.
Perform a "walk test" of the detector as explained in the detector's datasheet.
Perform a "Diagnostic test" as explained in the detector's datasheet.
event.
button repeatedly until the display reads [PERIODIC TEST]
.
2
5
.
D-304829 PowerMaster-10/30 G2 User's Guide
) button.
(Partition 1).
.
button.
2) PANIC,