Yamaha XJR1300 2007 Service Manual page 61

1. Meter leads
2. Handle crown
3. Left handlebar switch lead
4. Clutch hose
5. Left front flasher lead
6. Immobilizer unit lead
7. Left main switch lead
8. Atmospheric temperature sensor lead
9. Wire harness
10. Right front flasher lead
11. Brake hose 2
12. Brake hoses 1
13. Right handlebar switch lead
14. Immobilizer unit coupler
A. The throttle cable should be routed through the
headlight stay bracket guide.
B. Insert the meter lead, left handlebar switch lead
and the right handlebar switch lead in the top
hole of the headlight.
C. Clamp the left handlebar switch lead and clutch
hose below the handle crown with a band. The
left handlebar switch lead should be routed to
the inner side of the clutch hose.
D. The front flasher lead should be routed to the
front of the headlight stay. Right and left caps
should be installed facing the rear, and securely
fastened.
E. Insert the left front flasher lead, main switch
lead, immobilizer unit lead and wire harness
into the left hole in the bottom of the headlight.
F. Insert the right front flasher lead in the right
hole at the bottom of the headlight.
G. Clamp the right handlebar switch lead and
brake hose 2 with a band to the side of the
cable guide.
H. The band end should clamped facing upwards.
I. The band end should clamped facing inside.
J. Clamp the main switch lead, immobilizer unit
lead, left handlebar switch lead, right handlebar
switch lead, left front flasher lead and meter
lead.
K. Clamp the right front flasher lead and wire har-
ness atmospheric temperature sensor lead.
The wire harness should be aligned with the
positioning tape and clamped.
L. Fit the brake hose 1 to the painted section on
the master cylinder side. Put brake hose 1
against the master cylinder hose stopper and
tighten brake hose 2 at the same angle.
M. To the top hole.
N. To the right hole at the bottom.
O. To the left hole at the bottom.
2-38
CABLE ROUTING