Yamaha XJR1300 2007 Service Manual page 244

d. Put a piece of Plastigauge® "2" on each
crankshaft journal.
NOTE:
Do not put the Plastigauge® over the oil hole in
the crankshaft journal.
2
e. Install the crankshaft journal lower bearings
into the lower crankcase and assemble the
crankcase halves.
NOTE:
Align the projections "c" of the crankshaft jour-
G
nal lower bearings with the notches "d" in the
lower crankcase.
Do not move the crankshaft until the clearance
G
measurement has been completed.
c
d
f. Assemble the crankcase and tighten bolts to
the specified torque.
1
a
b
CRANKSHAFT ASSEMBLY
Crankcase bolt "1"–"15", "28",
"30"(M8)
24 Nm (2.4 m•kg, 17 ft•lb)
Crankcase bolt "16"17", "32",
"34"(M10)
35 Nm (3.5 m•kg, 25 ft•lb)
Crankcase bolt "18"–"27", "29",
"31" "35"–"37" (M6)
12 Nm (1.2 m•kg, 8.7 ft•lb)
NOTE:
Tighten the bolts in the tightening sequence
G
cast on the crankcase.
"35" and "36" tighten with clamp, "1", "3", "5",
G
"7"–" and 10" have copper washers, "37" is
tightened with negative lead, and "2", "4" and
"6" have no washers.
M8×100mm bolt "1"–"10"
G
M8×45mm bolt "11"–"15"
G
M10×50mm bolt "16", "17"
G
M6 ×110mm bolt "18"
G
M6 ×95mm bolt "19", " 21"
G
M6 ×40mm bolt "20", " 23"
G
M6 ×50mm bolt "22", " 26"
G
M6 ×65mm bolt "25", " 37"
G
M6 ×30mm bolt "27"
G
M8×55mm bolt "28", "30"
G
M6 ×125mm bolt "24"
G
M6 ×70mm bolt "31"
G
M10×60mm bolt "32", "34"
G
M6 ×55mm bolt "35", " 36"
G
5-71