Removing The Rear Brake Caliper; Disassembling The Rear Brake Caliper - Yamaha XJR1300 2007 Service Manual

4. Install:
Brake pad shims
G
(onto the brake pads)
Brake pads
G
Pad support
G
NOTE:
Always install new brake pads, brake pad shims,
and a brake pad spring as a set.
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Use a caliper piston presser "1" to push back
the caliper piston.
b. Install a new brake pad shim onto each new
brake pad.
c. Install new brake pads and a new brake pad
support.
d. Install pad pin and clip.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
5. Check:
Brake fluid level
G
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-21.
a
1
4-33
6. Check:
Brake pedal operation
G
Soft or spongy feeling → Bleed the brake
system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-23.
EAS22590

REMOVING THE REAR BRAKE CALIPER

NOTE:
Before disassembling the brake caliper, drain
the brake fluid from the entire brake system.
1. Remove:
Union bolt "1"
G
Copper washers "2"
G
Brake hose
G
Brake caliper
G
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
EAS22620
DISASSEMBLING THE REAR BRAKE
CALIPER
1. Remove:
Brake caliper pistons "1"
G
Brake caliper dust seal/brake caliper piston
G
seal "2"
REAR BRAKE
a
2
1