Yamaha XJR1300 2007 Service Manual page 145

sure safe vehicle operation. Refer to "CA-
BLE ROUTING" on page 2-31.
ECA14160
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection "a" as shown.
3
a
1
2
2. Add the recommended brake fluid to the
proper level.
Brake fluid reservoir
G
(LOWER level mark "a" or over)
Recommended fluid
DOT 4
EWA13090
WARNING
Use only the designated brake fluid. Other
G
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
Refill with the same type of brake fluid that
G
is already in the system. Mixing brake flu-
ids may result in a harmful chemical reac-
tion, leading to poor brake performance.
When refilling, be careful that water does
G
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
ECA13540
CAUTION:
Brake fluid may damage painted surfaces
New
a
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
3. Bleed:
Brake system
G
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-23.
4. Check:
Brake fluid level
G
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-21.
5. Check:
Brake lever operation
G
Soft or spongy feeling → Bleed the brake
system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-23.
4-37
REAR BRAKE
a