Replacing The Front Brake Pads - Yamaha XJR1300 2007 Service Manual

5. Adjust:
Brake disc deflection
G
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Remove the brake disc.
b. Rotate the brake disc by one bolt hole.
c. Install the brake disc "1".
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
Brake disc bolt
18 Nm (1.8 m•kg, 13 ft•lb)
(Apply the LOCTITE®)
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be brought
within specification, replace the brake disc.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
6. Install:
Front wheel
G
Refer to "FRONT WHEEL" on page 4-2.
EAS22270

REPLACING THE FRONT BRAKE PADS

The following procedure applies to both brake
pad.
NOTE:
When replacing the brake pads, it is not neces-
sary to disconnect the brake hose or disassem-
ble the brake caliper.
1. Remove:
Clip "1"
G
Turn the pad pin with pliers to change to a po-
sition for easy removal of the clip.
Pad pin "2"
G
Pad support "3"
G
2. Remove:
Brake pads
G
3. Measure:
Brake pad wear limit "a"
G
Out of specification → Replace the brake
pads as a set.
1
4. Install:
Brake pad shims
G
(onto the brake pads)
Brake pads
G
Pad support
G
NOTE:
Always install new brake pads, brake pad shims,
and a brake pad spring as a set.
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Use a caliper piston presser "1" to push back
the caliper piston.
4-20
FRONT BRAKE
1
Brake pad lining thickness (inner)
5.5 mm (0.22 in)
Limit
0.5 mm (0.02 in)
Brake pad lining thickness (outer)
5.5 mm (0.22 in)
Limit
0.5 mm (0.02 in)
a
3
2