Yamaha XJR1300 2007 Service Manual page 15

Fuel meter
1
1. Fuel level warning indicator
2. Fuel meter
The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear towards "E" (Empty) as the fuel level
decreases. When the fuel level warning indica-
tor " " starts flashing, refuel as soon as possi-
ble.
NOTE:
This fuel meter is equipped with a self-diagnosis
system. If the electrical circuit is defective, the
following cycle will be repeated until the mal-
function is corrected: All the display segments
and symbol " " will flash eight times, then go off
for approximately 3 seconds. If this occurs, refer
to "SIGNALING SYSTEM" on page 7-19.
Clock mode
1. Clock
To set the clock:
1. Turn the key to "ON".
2. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
3. When the hour digits start flashing, push the
"RESET" button to set the hours.
4. Push the "SELECT" button, and the minute
digits will start flashing.
5. Push the "RESET" button to set the minutes.
6. Push the "SELECT" button and then release
it to start the clock.
2
1
Self-diagnosis devices
1. Error code display
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
odometer/tripmeter display will indicate a
two-digit error code.
If the multi-function display indicates such an
fault code, note the code number, and check the
vehicle. Refer to "FUEL INJECTION SYSTEM"
on page 7-25.
This model is also equipped with a self-diagno-
sis device for the immobilizer system.
If any of the immobilizer system circuits are de-
fective, the immobilizer system indicator light will
flash, and then the display will indicate a
two-digit error code.
NOTE:
If the display indicates error code 52, this could
be caused by transponder interference. If this
error code appears, try the following.
1. Use the code re-registering key to start the
engine.
NOTE:
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not
start the engine, re-register standard keys.
If the display indicates any error codes, note the
code number, and then check the vehicle. Refer
to "IMMOBILIZER SYSTEM" on page 7-69.
1-6
FEATURES
1