Adjusting The Exhaust Gas Volume - Yamaha XJR1300 2007 Service Manual

Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-9.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
11.Install:
FUEL TANK
G
Refer to "FUEL TANK" on page 6-1.
EAS20600

ADJUSTING THE EXHAUST GAS VOLUME

NOTE:
Be sure to set the CO density level to standard,
and then adjust the exhaust gas volume.
1. Turn the main switch to "OFF" and set the en-
gine stop switch to "ON".
2. Simultaneously press and hold the "SE-
LECT" and "RESET" buttons, turn the main
switch to "ON", and continue to press the but-
tons for 8 seconds or more.
1
NOTE:
All displays on the meter disappear except the
G
clock and tripmeter displays.
"dIAG" appears on the clock LCD.
G
3. Press the "SELECT" button to select the CO
adjustment mode "CO".
4. After selecting "CO", press the SELECT and
RESET buttons simultaneously for at least 2
seconds.
5. Press the "SELECT" and "RESET" buttons to
select a cylinder.
NOTE:
The selected cylinder number appears on the
clock LCD.
To decrease the selected cylinder number,
G
press the "RESET" button.
To increase the selected cylinder number,
G
press the "SELECT" button.
6. After selecting the cylinder, simultaneously
press the "SELECT" and "RESET" buttons
for 2 seconds or more to execute the selec-
tion.
2
7. Change the CO adjustment volume by press-
ing the "SELECT" and "RESET" buttons.
NOTE:
The CO adjustment volume appears on the trip-
meter LCD.
To decrease the CO adjustment volume, press
G
the RESET button.
To increase the CO adjustment volume, press
G
the SELECT button.
8. Release the switch to execute the selection.
9. Simultaneously press the "SELECT" and
"RESET" buttons to return to the cylinder se-
lection (step 5).
10.Turn the main switch to "OFF" to cancel the
mode.
3-8
ENGINE