Table of Contents
Advertisement
Assembly
figure 1
1.
Ensure that there is nothing obstructing the motherboard mounting area (e.g. cables).
2.
Gently place the motherboard, connectors first into the unit whilst lining it up with the chassis
motherboard pillars and rear panel connector holes.
3.
Fit 2x M4 6mm screws into the motherboard if the unit does not have a daughter expansion
board, See figure 1.
4.
Insert 5x M3 screws into the motherboard mounting points and tighten. You will find a mounting
point in each corner of the motherboard and one between the memory module and IDE Sock-
ets.
5.
Secure the connectors to the rear of the chassis with 6x No.4 10mm pan head screws and 2x
M3 6mm screws above the ethernet and s-video connectors. See figure 3.
figure 2
37
figure 3
Advertisement
Table of Contents
