Fitting The Cdrom Drawer Front (Plastic Version) - Imerge AX-Platform Service Manual

Fitting the CDROM Drawer Front (Plastic version)

CAUTION:
The CDROM drawer is likely to break if excessive force is applied during this procedure.
TOOLS:
Pin or Straighten out Paper clip (For manual eject if necessary)
PARTS USED:
PL00010-01 CD Drawer Front
PROCEDURE:
This procedure covers the fitting of the plastic CDROM drawer front that is clipped to the tray. See
'Removing the CDROM Drawer Front (Metal version)' for the removal of the painted metal variant.
figure 1
figure 4
1. While the unit is powered on, press the eject button to open the CD tray. See figure 1
In the unlikely event that you are unable to eject the CD tray, you can try the following methods.
Below the right hand corner of the CD drawer is a small manual eject pin hole, inserting a pin or
straightened out paper clip into this hole should open the drawer whilst the power is applied. If
this fails then you will need to remove the Front Panel (See page
*DA_REMOVE_FRONTPANEL*) to gain access to the CD drawer front.
2. With the drawer still open, place the unit into standby and then remove the power.
3. On the top of the drawer front are two prongs (see figure 3) and two clips at the bottom (see
figure 4).
4. There is a ridge at the front of the drawer where the part is fitted (see figure 5). Clip the drawer
front on the top first then gently lift the prongs over the bottom ridge of CD drawer.
5. Applying power to the unit will automatically close the CD drawer.
figure 2
figure 5
15
figure 3