Table of Contents
Advertisement
Fitting the Hard Disk Bracket
CAUTION:
The motherboard front panel display socket carries additional power, do not under any circum-
stances attempt to connect a cable plugged in this socket into the hard disk drives or CDROM drive.
This will short circuit the attached device and/or motherboard rendering it inoperable.
TOOLS:
Pozi-driv No.2 screwdriver
PARTS USED::
<P/NBR> 2x M4 6mm
<P/NBR> 2x M3 6mm
PROCEDURE:
figure 1
figure 4
1.
The hard disk drive bracket is fitted in the front right hand corner of the unit (figure 1), one side
is secured against the front right side of the chassis.
2.
Position the bracket over the screw holes ensuring the up folded metal is flush against the front
right side (figures 2 & 3) of the unit.
3.
Insert and tighten the two M4 screws beneath the hard disk cable end (figure 4) and then the
pair of M3 screws that secure the bracket to the front right side of the unit (figure 3).
4.
Fit the IDE ribbon (black connectors) into the hard disk(s) (figure 6) and motherboard socket
marked PL8.
5.
Fit the Power cable(s) to the hard disk(s) (figure 6) and motherboard socket marked PL12.
figure 2
figure 5
20
figure 3
figure 6
Advertisement
Table of Contents
