Imerge AX-Platform Service Manual page 11

figure 4
1. EMC stripes are used along the top front and back edges of the chassis. See Caution and
Figure 1.
2. The lip on the lid fits neatly under the top of the front panel (See figure 2). Insert the lids' lip into
the top of the front panel at a 35
3. You may have to apply a little downward pressure on the lid at the rear to align up the screw
holes.
4. Secure and tighten 6x M3 (Black) screws on the rear of the unit. See figure 4.
5. Secure and tighten 4x M3 (Bronze) screws on the left and right side of the unit. See figure 5.
figure 5
o
angle and slowly sit the lid down at the rear (See figure 3).
11