Removing The Lid; Fitting The Lid - Imerge AX-Platform Service Manual

Removing the Lid

TOOLS:
Pozi-driv No.1 screwdriver
PARTS USED:
MW00113-01 Cover (Black)
MW00105-01 4x Copper M3 (6mm) screws
PROCEDURE:
figure 1
1. Remove the 4x M3 (Copper) screws from the left and right side of the unit. See figure 1.
2. Remove the 6x M3 (Black) screws from the rear of the unit. See figure 2.
3. Gently slide the lid towards the rear then lift up to remove, store in a safe place to prevent
damage. See figure 3.

Fitting the Lid

CAUTION:
EMC stripes are used along the top front and back edges of the chassis which can make the lid
difficult to fit. Do not try to force the screws into the holes as this can cause either damage to the
chassis or the screws thread which may prevent you from removing the lid again. Apply a little
downward pressure on the lid at the rear to help line up the holes.
TOOLS:
Pozi-driv No.1 screwdriver
PARTS USED:
MW00113-01 Cover (Black)
MW00105-01 4x Copper M3 (6mm) screws (if applicable)
PROCEDURE:
figure 1
MW00036-01 6x M3 (6mm) Black Screws
figure 2
MW00036-01 6x M3 (6mm) Black Screws
figure 2
10
figure 3
figure 3