Table of Contents
Advertisement
Removing the Hard Disk Bracket
CAUTION:
The motherboard front panel display socket carries additional power, do not under any circum-
stances attempt to connect a cable plugged in this socket into the hard disk drives or CDROM drive.
This will short circuit the attached device and/or motherboard rendering it inoperable.
TOOLS:
Pozi-driv No.2 screwdriver
PARTS USED::
<P/NBR> 2x M4 6mm
<P/NBR> 2x M3 6mm
PROCEDURE:
figure 1
figure 4
1.
Remove Lid (See page *DA_REMOVE_LID*)
2.
Remove the Power cables and IDE ribbon (black connectors) if connected from the hard
disk(s). See figures 2 and 3.
3.
Locate and remove the two M4 screws beneath the hard disk cable end that fix the metal
bracket to the bottom of chassis. See figure 4.
4.
On the front right side of the chassis you will find a second pair of M4 screws to remove. See
figures 5 and 6.
5.
Carefully lift the hard disk and bracket assembly from the unit.
MW00109-01
M4 Shakeproof Washers Zinc
MW00043-01
M3 Shakeproof Washers Black
figure 2
figure 5
19
figure 3
figure 6
Advertisement
Table of Contents
