Table of Contents
Advertisement
Replacing the Fan
WARNING:
IMPORTANT: Risk of Electric Shock. Do not use a screwdriver above the PSU to access the fan,
attempting to do so will result in an electric shock.
TOOLS:
Long shafted Pozi-driv No.1 screwdriver
PARTS USED:
IC00154-01
Cooling fan
MW00058-01
4x M3 Plain Washers
PROCEDURE:
NOTE: The fan only operates when the motherboard temperature sensors require the unit to be
cooled down. A good indicator of whether the fan is working is that it begins to spin when power is
applied to the unit.
Disassembly
figure 1
1.
Remove the Power Supply before attempting this procedure. See page *DA_REMOVE_PSU*.
2.
The fan is directly powered from the motherboard, the plug is located next to the motherboard
power socket. Remove the three pin plug from the motherboard socket. (See page
*DA_MOTHERBOARD_LAYOUT* for motherboard layout)
3.
Carefully undo the four screws with the shake proof washers.
4.
Remove fan from its position.
Assembly
figure 1
1.
Remove the Power Supply before attempting this procedure, if not already done so. See page
*DA_REMOVE_PSU*.
2.
The fan is fitted to the front left hand side of the chassis, towards the rear, beside the power
MW00118-01
M3 x 18mm Silver Screws
figure 2
figure 2
23
figure 3
figure 3
Advertisement
Table of Contents
