Fitting The Cdrom Drawer Front (Metal Version) - Imerge AX-Platform Service Manual

Fitting the CDROM Drawer Front (Metal version)

CAUTION:
The CDROM drawer is likely to break if excessive force is applied during this procedure.
TOOLS:
Pin or Straighten out Paper clip (For manual eject if necessary)
PARTS USED:
PL00010-01 CD Drawer Front
PROCEDURE:
This procedure covers the fitting of the painted metal CDROM drawer front that is clipped to the
tray. See 'Removing the CDROM Drawer Front (Plastic version)' for the removal of the plastic
variant.
figure 1
1. With the lid on and while the unit is powered, press the eject button to open the CD tray (See
figure 1).
In the unlikely event that you are unable to eject the CD tray, you can try the following methods.
Below the right hand corner of the CD drawer is a small manual eject pin hole, inserting a pin or
straightened out paper clip into this hole should open the drawer whilst the power is applied. If
this fails then you will need to remove the CDROM drive (See page
*DA_REMOVE_CDROM_DRIVE*) to gain access to the CD drawer front.
2. With the drawer still open (see figure 2), place the unit into standby and then remove the power.
3. The drawer front is fitted to the CDROM drive with 2x 3M double sided sticky pads on the rear
side of the metal drawer. If the drawer front has been used before then remove all traces of the
double sided sticky pads before proceeding.
4. Place one at each end at about 1cm from the edge.
5. Centrally align the metal drawer front with the CDROM drawer front and carefully apply pres-
sure so that the pads to stick.
figure 2
13
figure 3