Setup Tool Ports - Omron E5C User Manual

Key
Mode Key
M
Down Key and Up
Key
D
U
Shift Key (PF Key)
S

Setup Tool Ports

Setup Tool
port
Top-panel Setup
Tool port
Front-panel Setup
Tool port
(E5EC/E5AC only)
Front-panel Setup
Tool port (E5DC
only)
E5@C Digital Temperature Controllers User's Manual (H174)
Name Overview
Changes the
parameter that is
displayed within a
setting level.
Set the value.
Operates as a
user-defined
function key.
000
Name
Use the E58-CIFQ2 USB-Serial Conversion Cable to connect the E5@C to
the computer (i.e., the CX-Thermo Support Software).
Use the E58-CIFQ2 USB-Serial Conversion Cable and the E58-CIFQ2-E
Conversion Cable to connect the E5EC, E5AC, or E5DC to the computer
(i.e., the CX-Thermo Support Software).
3 Part Names and Basic Procedures
Description
• Press once to go to the next parameter.
• Hold to go to the previous parameter.
• Hold the key to increment or decrement the value
quickly.
• Any changes in settings are applied at the following
times:
• After 3 seconds elapse
• When the M Key is pressed
• When the level is changed with the O Key
• Press the S to select the digit to change.
The PF Key operates as a Digit Shift Key by default.
Example: If you set the PF Setting parameter to STOP,
operation will stop when you press the PF Key for at
least 1 second.
• Press the PF Key once to display the Monitor/Setting
Item Level.
The parameter that is displayed is set in the
Monitor/Setting Item parameters in the Advanced
Function Setting Level.
Description
3
3 - 7