Omron E5C User Manual page 225

a-m
• This parameter switches the Controller between Automatic and Manual Modes.
• If the O Key is pressed for at least 3 seconds when the Auto/Manual Switch parameter is
displayed, the Manual Mode will be entered and the manual control level will be displayed.
Operation
• This parameter will not be displayed if an event input is set to "MANU" (auto/manual).
Related Parameters
See
See
PID ON/OFF (Initial Setting Level): Page 6-44
Auto/Manual Select Addition (Advanced Function Setting Level): Page 6-72
m-sp
To use the multi-SP function, preset the eight set points (SP 0 to 7) in the Adjustment Level,
and then switch the set point either by operating the keys or by using external input signals
(event inputs).
Function
This parameter is used to select set points 0 to 7.
rsp
This parameter is used to monitor the remote SP.
Monitor
Remote SP lower limit −10% to Remote SP upper limit +10%
Related Parameters
See
See
SP Mode (Adjustment Level): Page 6-21
Remote SP Enable (Advanced Function Setting Level): Page 6-81
Remote SP Upper Limit (Advanced Function Setting Level): Page 6-82
Remote SP Lower Limit (Advanced Function Setting Level): Page 6-82
E5@C Digital Temperature Controllers User's Manual (H174)
Auto/Manual Switch
Multi-SP Set Point Selection
(Set Points 0 to 7)
Remote SP Monitor 000
Monitor range
The Event Input Assignment 1 to Event Input
Assignment 6 parameters must not be set to Auto/
Manual and the Auto/Manual Select Addition
parameter must be set to ON. The control must be
set to 2-PID control.
The Number of Multi-SP Points parameter must not
be set to OFF and the Event Input Assignment 1 to
Event Input Assignment 6 parameters must not be
set to "Multi-SP No. switching bit 0" to "Multi-SP
No. switching bit 2."
There must be a remote SP input.
The ST parameter must be set to OFF.
The Remote SP Enable parameter must be set to
ON.
6 Parameters
6
Unit
EU
6 - 9