Using The Simple Program Function; Simple Program Function - Omron E5C User Manual

5-14 Using the Simple Program Function

5-14-1 Simple Program Function

• The simple program function can be used for the following type of control.
• The program will start when the Program Start parameter is changed from RSET to STRT. END will
be displayed on the No. 2 display and the output assigned as the program end output will turn ON
after the time set in the Soak Time parameter has expired in the wait band. The Program Pattern
parameter can be used to select moving to STOP mode or continuing operation in RUN mode after
the program ends.
Parameters Related to the Simple Program Function
Parameter name
Program Pattern
Program Start
Soak Time
Soak Time Unit
Wait Band
Soak Time Remain
Monitor
* The setting unit of the Wait Band parameter is %FS for Controllers with Analog Inputs and the setting range is
OFF or 0.01 to 99.99.
Program Pattern
Either of two program patterns can be selected. The simple program operation will not be performed
if the Program Pattern parameter is set to OFF.
(1) Pattern 1 (STOP)
Control will stop and the STOP mode will be entered when the program has ended.
Set point
RSET → STRT
E5@C Digital Temperature Controllers User's Manual (H174)
SP
Set point
PV
RSET → STRT
Display Set (monitor) values
ptrn
OFF, STOP, CONT
prst
RSET, STRT
soak
1 to 9999
m (minutes)/h (hours)
t-u
wt-b
OFF or 0.1 to 999.9*
0 to 9999
sktr
SP
PV
Soak time
Automatically switches from
RUN to STOP mode.
Wait band
Wait band
END display
Soak time
END output
Select either
STOP or RUN.
Unit
---
---
min or h
---
°C or °F*
min or h
Wait band
Wait band
END display
END output
5 Advanced Operations
000
Display level
Initial Setting Level
Operation Level
Adjustment Level
Advanced Function
Setting Level
Adjustment Level
Operation Level
5 - 39
5