Confirming That Web Acceleration Is Operational - Hughes HX90 Installation Manual

3. If the TCP Acceleration Status is Disabled, restart the router:
a. Go to the System Control Center home page.
b. In the Help section, click
4. If TCP Acceleration is still disabled, power cycle the router:
a. Unplug the power cord from the power source.
b. If the router is connected to a DC power source, unplug the DC input cable
from the satellite router's power supply.
c. Wait 10 sec.
d. Plug the power cord back into the power source.
e. If the power source is DC, plug the input cable back into the power supply.
CAUTION
Do not power cycle the satellite router by unplugging the power cord from the
router's rear panel. Doing so could result in static electricity discharge that could
shock you and/or damage the router.
5. If TCP Acceleration is still disabled, power cycle the Ethernet device according to
the device documentation.
6. If TCP Acceleration is still disabled, restart the computer.
7. Check the TCP Acceleration Status field again.
If TCP Acceleration is enabled but you still cannot access the Internet, go to
Confirming that Web Acceleration is operational on page 95.
If TCP Acceleration is still disabled, contact Installer Support for assistance.
Note: TCP Acceleration Status may also be
receive or transmit link) or Impaired. Impaired status may result from a
number of factors; in many cases it clears within a minute or two.

Confirming that Web Acceleration is operational

Note: This section applies only if the NOC operator has enabled Web Acceleration on
the satellite router.
Web Acceleration is a Hughes feature that enhances browsing performance on
non-secure web sites. Follow these steps to confirm that Web Acceleration is
operating properly:
1. From any System Control Center page, observe the System Status button
indicator.
• If the indicator button is green, Web Acceleration is functioning normally.
• If the indicator button is yellow, Web Acceleration may not be operational.
Continue to the next step.
2. Click the
Restart HX90
link to access the System Status page.
System Status
.
(problem with the
Not Operational
Chapter 8 • Troubleshooting
1039456-0001 Revision A
95