Receive Antenna Pointing - Ku-Band - Hughes HX90 Installation Manual

Receive antenna pointing — Ku-band
Note: This section applies to Ku-band installations only. For Ka-band, skip this
section; go to Registering the satellite router on page 52.
Follow these steps to receive-point the antenna using the displayed signal strength,
as shown in Figure 31. Adjust the antenna to point it as instructed in the antenna
installation guide.
Display Signal Strength
1. Click
the Signal Quality window.
Figure 31: Receive Pointing screen with signal quality window
Note: The Signal Quality window is small and may not appear on top. If it is not
on top, minimize other windows until you can see it.
If the radio assembly is Ku-band and the text next to this checkbox reads
Validate KA Antenna Pointing
this case go back to the Receive LNB Selection screen and select the correct LNB.
2. Use the Signal Quality indication to peak receive pointing as instructed in the
antenna installation guide.
Note: You must peak the signal even if the antenna is locked to it. When the
signal is locked, a check mark appears in the Perform ACP checkbox on the
Receive Antenna pointing screen.
3. After you have peaked the signal, click
on the Receive Antenna Pointing screen to open
, you probably selected the wrong LNB. In
Close
to close the Signal Quality window.
Chapter 4 • Commissioning the satellite router
1039456-0001 Revision A
49